Currently working on painting the parts, glueing the interface board and putting the copper tape to it and also to the instruction blocks. To make it more difficult, the laser cut slots of the instruction blocks are slighlty narrower than the 5mm copper tape. So I need to cut off a bit from the tape so it goes through the slot. Fortunately I don’t have this problem with the too narrow slots on the interface board.
Another thing that was too small were all the holes for the 5mm LEDs on the interface board.
Working on the #primo project @primo_io pic.twitter.com/ISAoIpyJti
— Roman Müller (@roman_m) April 7, 2014
Can’t wait to finally start soldering!